Suspension Levelling Shim Set – T3

Correct that Westy Lean.

Ask a question about this product

Please fill in the information along with your question below and we will get back to you as soon as possible.

Product Question

  • This field is for validation purposes and should be left unchanged.

Details

Another Brickwerks exclusive!

Basically, in camper conversions you tend to get a lot of weight down one side of the vehicle, the driver, the cupboards, the fridge, the water tank, the waste tank, the gas tank… you get the picture, all the heavy stuff on one side, next to nothing on the other.
So, as you can imagine a lot of time Campers tend to lean to one side as that’s where all the weight is.
The lean becomes more noticeable once the vehicle is lowered as all those straight lines of the bumpers get closer to the road.
Our plan of attack was to shim up one side of the suspension to try to jack the van back to where it should be using a bit of maths and some good old Yorkshire engineering (trial and error!)

So, what we have come up with are 2 CNC Machined aluminium shims to fit above your springs.
The front shim is shaped such that it attaches to the rubber spring insulator and fits between the insulator and the vehicle body, it is designed so that the spring, or insulator cannot become dislodged easily.
The rear shim again fits between the van body and the upper spring insulator, it has a flat side to face the wheel for those with uber wide rear wheels as not to catch the tyre, or if body modification has taken place to clear the wheels these shims will still fit!
The shims are sold as a kit, one front, one rear.
As stated they are made from CNC Machined Aluminium, anodized satin black

Now, all vans are different, we have tried to make them where they will be suitable for everyone.
We have trialed these sets on our own vehicles, and customers with good results ranging from millimeter perfect to still down by about 5mm on the drivers side to 5mm or so up on the drivers side.
What we are trying to say is that producing a product that will make every van out there millimeter perfect is not going to happen, so, that said these shims are a compromised, but hey, it’s gonna be a load better than it was!!

The shim set should counteract around 20mm of lean on a 2WD T3 measured at the wheel arch lip to floor.

Additional Information

Our Part No.

K00043

Manufacturer

T3 Tuning

£78.37 (Inc VAT)

This kit consists of the following individual parts:

PLEASE NOTE: If any of the items in the kit have a QTY of 0 they are unfortunately out of stock and will not be delivered if ordered.

Out of stock