Speedo Drive Repair Gear – T3 Syncro / 7/19 / Brown

Syncro models only - check application carefully.

Ask a question about this product

Please fill in the information along with your question below and we will get back to you as soon as possible.

Product Question

  • This field is for validation purposes and should be left unchanged.

Details

Originally “Brown” this is the speedo drive for 16″ models with front diff – AOM, AOL, ALM, ALN

Precision engineered ali-bronze gear to be bonded to your original drive shaft.

Fitting notes:
Remove damaged plastic gear with a hacksaw or sharp knife (shaft is hardened) and remove all traces of plastic within the shaft knurling.
Degrease new pinion and shaft with brake cleaner (not gasolene) and scrub with a clean brush.
Check that shaft fits easily into pinion bore and bottoms out.
Remove shaft from pinion.
Liberally coat shaft knurl and end with high strength/high temp retaining compound (Sachet of Loctite 680 now included), and fit into pinion.
Remove excess compound and allow to cure before refitting.

Caveats:
Proper degreasing is essential for a good bond between shaft and pinion.
Owners should satisfy themselves that the speedo pinion is of the correct ratio before fitting, since the driving worm wheels fitted to various differential units are of different diameters and will fail to mesh properly with the incorrect pinion. This will cause immediate or premature failure.
Use of inferior or expired retaining compounds may result in the pinion slipping.
It is essential to check that the pinion shaft is free running inside its alloy bearing sleeve. If found to be tight, notchy or “digital”, the seal should be removed from the sleeve and the bore resized with a sharp 10.0mm reamer.

Additional Information

Our Part No.

T3S409181H

Manufacturer

025 Motorsport

VW No

094 419 181 H

£82.68 (Inc VAT)
In stock

3 in stock

Returns: 28 Days