Original Style seat belt kit for the rear of a T3.
RIGHT side for the Drivers Side on a Right Hand Drive. Passenger side on a Left Hand Drive
Supplied with bolts and washers to attach the bracket to the body, and an automatic retracting quality seat belt.
It has a webbing buckle.
Kit is also supplied with a fitting kit to attach the belt to the body, there's plenty of bolts, washers and spacers to suit your application.
Original VW style mounting bracket - made in Germany. Allows mounting of the belt reel into the space where VW intended the belts to go, behind the panel. So no nasty intrusions into your bed space and no chance of damage due to flying push chairs and beer cans!
Plus, the mechanism is less likely to get jammed up with fluff and half eaten boiled sweets.
VW Only fitted seat belts to models with widows, so Caravelle, Multivan and Westfalia models, all of which came with seat-belt mountings already in the body of the van.
Lots of UK camper conversions are based on vehicles that left the factory as delivery vans.
Delivery vans do not have seat-belt mountings already in the body, so you will need to order other mounting brackets if you are fitting to a vehicle which started life as a panel van (see related items).
Rule of thumb...
If you vehicle has factory windows in the rear (Models 253, 254, 255 and 256) then your van will have seat-belt mounts.
If your camper left the factory as a Panel van (Kastenwagen, type 251 or 252) then you will need 3 extra mounting plates as listed below in the related products.
Also, for Westfalia models you will need some small rivets to re-attach the interior panels as the press studs for the rear mosquito net, we do stock these, again, in the related items - you will require 3 for each side.
Yes, it's expensive, but it works!
The belts we now supply are of a much higher quality than the older versions, and much longer too.
The belts are designed to be mounted at a slight angle (8°) but are taken from another application.
Left is the left of the vehicle as you are sat in the drivers seat.
Note, the fitting guide below shows our own over engineered brackets. This is the only difference in the guide, everything else is the same.